Preface ​

Support for running Docker virtualization on various systems, including Linux, Android, and Windows.

If your host does not have an IPV6 subnet and you want to assign IPV6 addresses to containers, then please check the Customize partition in the LXD module for the Attach a free IPV6 address segment to the host, and attach an IPV6 subnet to the host before installing the environment.

Setting Up Virtual Memory ​

Unit conversion: Inputting 1024 results in 1G of SWAP - virtual memory. Virtual memory occupies disk space and is automatically utilized when the physical memory is insufficient. However, this leads to high IO usage and CPU performance overhead.

It is recommended to allocate virtual memory twice the size of your physical memory.

Command:

curl -L https://raw.githubusercontent.com/spiritLHLS/addswap/main/addswap.sh -o addswap.sh && chmod +x addswap.sh && bash addswap.sh

Environment Setup ​

• Detect the system environment and install the corresponding components
• Install docker and docker-compose.
• Download some configuration scripts required by default
• Detect if there is an IPV6 address, check if it is greater than or equal to /112, and if so, configure the docker's ipv6 network.
• If all the above conditions are met, create ndpresponder docker and radvd so that IPV6 allocation supports ndp broadcasting and auto-allocation.
• Support for x86_64 and ARM architecture servers

Command:

curl -L https://raw.githubusercontent.com/oneclickvirt/docker/main/scripts/dockerinstall.sh -o dockerinstall.sh && chmod +x dockerinstall.sh && bash dockerinstall.sh

OR

bash dockerinstall.sh